C6 Corvette Z06 / GS / 427 NoviStretch™ Front End Mask Cover and Mirror Cover Bundle

This bundle pairs the C6 Z06/GS/427 Corvette NoviStretch™ Front End Mask Cover with a set of NoviStretch™ Mirror Covers, so the front of your car and both mirror housings are protected in one purchase. Both use the same perforated stretch-mesh fabric, which lets air and water pass through rather than collecting against the paint, and both go on and come off without cutting, drilling or any permanent change to the car.

Fitment

• Fits 2005 to 2013 C6 Corvette Z06, Grand Sport and 427 models
• Fits coupes and convertibles
• Standard-body C6 Corvettes use the C6 bundle instead
• If you have a ZR1, get in touch before ordering and we will confirm the right fit for you

What comes in the box

• The C6 Z06/GS/427 Corvette NoviStretch™ Front End Mask Cover
• A pair of NoviStretch™ Mirror Covers, one for each side
• Hardware kit for the mask
• Installation instructions and warranty information

Installing the mask

The first install takes about 15 minutes. You replace a set of existing screws around the front of the car with the snap-head studs supplied in the box, then stretch the mask across the front and snap it on. After that one-time setup, the mask goes on and comes off in under a minute.

Installing the mirror covers

The covers stretch over the mirror housings. The C6's housings are symmetrical, so the two covers are interchangeable and it does not matter which one goes on which side. Make sure the housings are clean and free of sand and grit first.

Good to know before you order

• Ground clearance. These cars sit low, and lower still with ground effects. Watch for parking blocks, curbs and steep driveway entrances, since contact with those can tear the mask.
• Track use. These were built for street and highway driving. Owners have run the mask at track events with good results, though the debris and speeds out there wear it faster, and NoviStretch does not guarantee how it performs on track.

Airflow and operating temperatures

The mask does reduce airflow somewhat, and you may see a small rise in temperatures, more so in heavy rain. Working with manufacturers, dealers and thousands of owners, NoviStretch has found those temperatures stay inside the acceptable range and never climb to the point of overheating. They have run the mask on Z06 and ZR1 Corvettes and on other high-horsepower cars built to force as much air into the engine as possible, without a reported problem. Because the mesh is perforated rather than solid, it shields the grille, radiator and coolers from debris instead of sealing them off, which matters on the LS7 and LS9 cars.

Care

Rinse the mask and covers with water to clear dirt and debris, squeeze them out and let them air dry. Hand wash only when they need it, using a concentrated soap solution on the dirty areas. No bleach, no fabric softener, no clothes dryer. Make sure the paint underneath is clean and free of sand and grit before you install anything, and take everything off before a pressure washer or an automatic car wash.

Special Features of NoviStretch™ C6 Corvette Bras

• Synthetic Stretch Mesh Fabric and Heavy Duty Elastic Trim
• All black “hidden” hardware
• Snap and Strap© Installation
• Patented Design 100% Manufactured in USA*
• 12 – Month Limited Warranty

Special Benefits of NoviStretch™ C6 Corvette Bras

Need replacement mounting hardware down the road? Get in touch and we will take care of you.